Estimate Shipping Cost
Details
Boaters' Resale Shop of TX 2508 2308.24 NAVPOD RMX4500-08 RAIL MOUNT FOR GARMIN * PRE-CUT FOR GARMIN GPSMAP 922/922 Plus/922xs/922xs Plus/942/942 Plus/942xs/942xs Plus * ITEM IS MISSING IT'S STAINLESS STEEL ARM, OUTER RUBBER GASKET & SECURITY SCREWS * SEE ALL 7 PHOTOS & ALL DETAILS * SOLD IN CONDITION PICTURED * SOME ASSEMBLY MAY BE REQUIRED WHEN SHIPPING * ITEM WAS PREOWNED, USED, IS MISSING IT'S STAINLESS STEEL ARM, OUTER RUBBER GASKET & SECURITY SCREWS BUT IS IN FAIR PHYSICAL CONDITION AND APPEARS TO BE OPERATING PROPERLY BUT HAS NOT BEEN TESTED FURTHER
OVERALL SIZE: OVERALL ASSEMBLY USABLE FACE: MAX CUT-OUT
* DEPTH: 5.5" DEPTH: 6.3" DEPTH: 4.125"
* HEIGHT: 7.69" HEIGHT:10.25" HEIGHT: 6" HEIGHT: 5.5"
* WIDTH: 11.86" WIDTH: 13.91" WIDTH: 9.95" WIDTH: 9.5"
Description
RailMount NavPods are best used for mounting of an autopilot control, sailing instrument, or small chartplotter onto an existing pedestal guard. Fits onto any 1″, 1.125″, or 1.25″ diameter tube. A Stainless Steel arm is used to mount the NavPod housing. The NavPod can rotate 180 degrees for easy viewing while sitting under the dodger on a rainy day. All wiring runs from the NavPod, down the center of the stainless steel arm (available space is 0.75″ inside the narrowest part of the arm, so keep this in mind for planning your cable run; most transducer cables will not fit through the arm), and into the pedestal guard. This application provides a clean and sturdy installation for electronics, without replacement of the pedestal guard.
-Please look at all pictures and read entire description before buying.
-Mounting hardware is only included if it is shown in the pictures.
*We are striving for 5 star ratings in every category from all of our customers. If you are not 100% satisfied with your order, please email me with any problems before leaving negative/neutral feedback, or anything less than 5 stars. I will do my best to resolve the issue. Thank You -Paul
Specifications
| Condition | Used |
|---|---|
| Brand | NAVPOD |
| Manufacturer Part Number | RMX4500-08 |
| Condition Description | SEE ALL 7 PHOTOS & ALL DETAILS * SOLD IN CONDITION PICTURED * SOME ASSEMBLY MAY BE REQUIRED WHEN SHIPPING * ITEM WAS PREOWNED, USED, IS MISSING IT'S STAINLESS STEEL ARM, OUTER RUBBER GASKET & SECURITY SCREWS BUT IS IN FAIR PHYSICAL CONDITION AND APPEARS TO BE OPERATING PROPERLY BUT HAS NOT BEEN TESTED FURTHER -Please look at all pictures and read entire description before buying. -Mounting hardware is only included if it is shown in the pictures. *We are striving for 5 star ratings in every category from all of our customers. If you are not 100% satisfied with your order, please email me with any problems before leaving negative/neutral feedback, or anything less than 5 stars. I will do my best to resolve the issue. Thank You -Paul |